Friday
 1) ramp magnet ramp to 2T

 2) TEC measurements at 2T
  - start with 29.6 MeV/c tune, but slits/jaws narrower than nominal
  - check that PC currents aren't too high (no more beam gas problem?)
  - open F0 slits to nominal ~2kHz rate setting (18x60mm)
  - with nominal 29.6MeV/c tune, and 100% He in degrader
    take ~1 million triggers with TEC and detector HV on
  - nominal 29.6MeV/c with Q6,Q7+/-10%  200k events each
  - scale from 29.6MeV/c tune up to 40MeV/c, open F0 if need more rate
    take ~250k events?

 3)- Take a deep breath, hold onto your metal objectsh tightly, 
    then out TEC with non magnetic tools
   - change B1 probe cables in area to #1 positon
   - move beampackage foil degrader to position 8 or 9 to do upstream stops
   - set gas degrader to 65% He???

 4) Try to get more info about correct B2 setting.
    - Setup 29.6MeV/c tune with B2 setting that centers <x>=0 from TEC
      measurements at z=-134cm.  This setting is B2=949G.
    - with extra foil degraders stop muons in dense stack/ position 8 or 9
    - adjust B2 +/- 1,2,3 G to maximize mean stopping z from
      "trackrange: restricted stopping Z for muons" histogram from mofia anal
    - after first run, start getting monitoring software running

 5) Center muon stopping distribution in center of stopping target
    - use nominal 29.6MeV/c tune
    - start with 65%He
    - take out foil degrader down in the area (position 0)
    - wait ~30min per setting for gas degrader to finish "purge"
    - take a run and look at -12cm to 12cm range of 
      "trackrange: restricted stopping Z for muons"
       centered mean of histogram is -0.745 
       (-0.845 moves upstream by 4.5microns of Aluminum)
    - adjust He+/-XX% as needed until we get centered

Friday late night -> Sunday night sometime:
8) Start a nominal dataset of 300 runs (of ~850k events per run)
   - wait for gas degrader to be fully purged (how long?)
   - use nominal 29.6MeV/c tune
   - take data for about 2days

Sunday night sometime:
9) Take a systematic set of 300 runs of slightly upstream stops
   - how far to move restricted stopping Z for muon mean?  ask Dave