Detailed Runplan -- For first few days of running
Last updated: Oct 15/2004 1pm

Start with Be production target, TEC in, Mtec trigger
Do the following tests interspersed with consistency check runs at 
surface muon (29.6MeV/c) settings (2 times per shift):
0) get TEC data with collimator to allow for new t0 & alignment
   of TEC, then take collimator out for rest of tests

1) look at nominal 29.6 tune, adjust B2 to center in TEC
- refer to the nominal settings page for tune

2) check F1H position for: 
<dx> = 0 (<3mr) at <x>=0 (<2mm),
check for effect of window valve

--> may need to iterate 1),2)

3) Surface muon edge scan: 25,26,27,28,28.5,28.8,
20 points in 28.6 to 31.0 MeV/c, 31.5,32,32.5,
32.7,32.8,32.9,34,35
record total T1ION and M scalers for each run, you can get these
by grepping run17???.odb
- tune file is 29.6 tune, with channel scaled to the new p
- may need to adjust analysis cut on TCAP vs M for muons, see 
zero'th order TEC analysis instructions
-

3.1) Develop tune for far downstream stops
 - try 32.8 MeV/c muons, with channel midplane degrader
   to eliminate beam positron triggers, possibly pion trig
 - need to put in a foil to stop cloud mu's at downstream end of
 detector (but not for TEC tests)

4) F0 scans at 29.6MeV/c

4.5) Try to find a momentum of pion (somewhere in 30-50MeV/c) that 
   is seen in TEC and seen in upstream of detector to use for
   aligning TEC and detector.  So do a scan of pions between
   30-50MeV/c until TEC no longer gets a measurement


5) 10mm Graphite at 100 uA.  --- does it work?
- test window valve
- Q6,Q7 scan to see if there is a new optimal tune
- repeat 1),2?),3)really well!!, 4)
- establish settings for 1kHz, 2kHz, 4kHz muons/s

6) proton beam stability tests with Graphite target

7) 2mm(x1.4mm) graphite target
- Q6,Q7 scan to see if there is a new optimal tune
- repeat 1),3),6)

8) Go back to production target we will use for running and take alignment
data (8 may come earlier if the opportunity arises)
- Translational Alignment: 
  4 runs with the tune used for runs 17484/5 
Rotational Alignment:   
 15 runs with the tune used for run  17486
 15 runs with the tune used for run  17487
t0 calibration:
 Use 120MeV/c spray tune with B2 centered, 
 1-2 runs with M trigger, 1-2 runs with DS trigger
- see the nominal settings page for the required tune settings


9) magnet on...